Westinghouse Jet Plus 42″ Indoor Ceiling FanThe Jet Plus is a 42″ (105cm) triple bladed ceiling fan. The motor and housing are finished in brushed nickel and complete with wengue/silver blades. The Jet Plus also has a triple spot light in brushed nickel.Diameter – 42″ 105cm – – Fan ControlRemote Control IncludedRemote Control – – – – YesWall Control – – YesLighting Option – – Triple spotLamps Required3 x 40w E14 R50 (not included)Winter Operation – – YesBlade Pitch – 14 degreesMotor Size – – 153mm x 12mm – – Wattage – – 40/34/32RPM – 280/230/185Amps – – 0.18/0.15/0.16Net Weight – – – – 6.4KGInstallation – ** Drop rod only12″ (30.5cm) 18″ (46cm) Drop rod possible – Yes Dimensions (cm): – A – B – C – D – E – F – 18296171337Installation Clarification* Dual Mount System – These versatile ceiling fans may be installed with or without the extension drop rods included in the packaging. This flexibility allows you to install the fan either close to the ceiling or at a lower level in rooms with higher ceilings.** Drop Rod Only – Drop Rod ceiling fans must be installed with the Drop Rod supplied, you may replace the drop rod with rod’s having a length of either 12″ or 18″. The option for a 12″ or 18″ Drop Rod varies for each model.*** Hugger – Specially designed for rooms with lower ceilings, hugger fans can not be installed with a down rod.
The Westinghouse wall control is suitable for use with all Westinghouse ceiling fans. This unit is white and has 4-speed controls and off control for the fan. This wall fan control can be used with all Westinghouse fans, but you should be aware that for fans that are supplied with the remote control module, you can not connect the remote control and the wall control at the same time. Only one control can be wired to the fan unit. The wall control does not require a neutral or earth connection but does require a live feed, and two separate live return to the fan unit – one for the light and one for the fan. This may require an additional cable to be run to the wall control location as three live wires are required in total. With some fan units, the internal live feeds for the fan and the light are connected together in the ceiling rose of the fan, for connection to a standard on/off light switch and when used with the remote control option. This means that your electrician might have to adjust the wiring in the ceiling rose of the fan to enable independent control of the light and fan when installing this wall control unit instead of a remote control module.